Greetings, one and all! This week had a considerable dose of
real world interruptions, but we still managed to get a fair amount of work
done. Chief among our achievements is the further fleshing out of the cuirass
design. After affixing the shoulder straps, we gradually built up the front and
collar area. Next up, the spine and shoulder blade plates.
On top of that, we repurposed a plate intended for the gut area into a fourth “horn” on the back of the helm. The design was beginning to look a little unbalanced, otherwise. (Note: After publishing this picture, I realized I'd put the "horn" on lower than I'd planned, so it has since been cut off and moved higher.)
Last, but not least, we are beginning to look into what would be required to resume stunt meets again. Given the current state of the world, it could be a while before meet pictures appear on this blog again, but we’re preparing for the time when we can do just that.
Well, that’s about all for this week. Until next time!
No comments:
Post a Comment